Snmp-Server - Allied Telesis AT-AR3050S Command Reference Manual

SNMP C
OMMANDS
-
SNMP SERVER

snmp-server

Overview Use this command to enable the SNMP agent (server) on the device. The SNMP
agent receives and processes SNMP packets sent to the device, and generates
notifications (traps) that have been enabled by the
command.
Use the no variant of this command to disable the SNMP agent on the device.
When SNMP is disabled, SNMP packets received by the device are discarded, and
no notifications are generated. This does not remove any existing SNMP
configuration.
snmp-server [ip|ipv6]
Syntax
no snmp-server [ip|ipv6]
Default By default, the SNMP agent is enabled for both IPv4 and IPv6. If neither the ip
parameter nor the ipv6 parameter is specified for this command, then SNMP is
enabled or disabled for both IPv4 and IPv6.
Mode Global Configuration
Examples To enable SNMP on the device for both IPv4 and IPv6, use the commands:
awplus#
awplus(config)#
To enable the SNMP agent for IPv4 on the device, use the commands:
awplus#
awplus(config)#
To disable the SNMP agent for both IPv4 and IPv6 on the device, use the
commands:
awplus#
awplus(config)#
To disable the SNMP agent for IPv4, use the commands:
awplus(config)#
C613-50077-01 REV A
Parameter Description
ip
Enable or disable the SNMP agent for IPv4.
ipv6
Enable or disable the SNMP agent for IPv6.
configure terminal
snmp-server
configure terminal
snmp-server ip
configure terminal
no snmp-server
no snmp-server ipv4
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
snmp-server enable trap
1959