Probe Timeout - Allied Telesis AT-AR3050S Command Reference Manual

D H C
YNAMIC OST ONFIGURATION

PROBE TIMEOUT

probe timeout
Overview Use this command to set the timeout value in milliseconds that the server waits for
a response after each probe packet is sent. Lease probing is configured on a
per-DHCP pool basis.
The no variant of this command sets the probe timeout value to the default
setting, 200 milliseconds.
probe timeout <50-5000>
Syntax
no probe timeout
Default The default timeout interval is 200 milliseconds.
Mode DHCP Pool Configuration
To set the probe timeout value to 500 milliseconds for pool P2, use the commands:
Examples
awplus#
awplus(config)#
awplus(dhcp-config)#
To set the probe timeout value for pool P2 to the default, 200 milliseconds, use the
commands:
awplus#
awplus(config)#
awplus(dhcp-config)#
Related probe enable
Commands
probe packets
probe type
show ip dhcp pool
C613-50077-01 REV A
P (DHCP) C
ROTOCOL OMMANDS
Parameter
<50-5000>
configure terminal
ip dhcp pool P2
configure terminal
ip dhcp pool P2
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
Timeout interval in milliseconds.
probe timeout 500
no probe timeout
1849