Allied Telesis AT-AR3050S Command Reference Manual page 1744

Next-generation firewall
Hide thumbs Also See for AT-AR3050S:
Table of Contents

Advertisement

A
T
M
F
LLIED
ELESIS
ANAGEMENT
-
ATMF VIRTUAL
LINK
The tunneled link may operate via external (non AlliedWare Plus) routers in order
to provide wide area network connectivity. However in this configuration, the
routers perform a conventional router to router connection. The protocol
tunneling function is accomplished by the AMF nodes.
NOTE
terminates the tunnel connection, because you must pre-configure the local IP address
and tunnel ID on that remote device.
Example 1
Use the following commands to create the tunnel shown in the figure below.
Figure 36-7: AMF virtual link example
Node_10(config)#
remote-id 2 remote-ip 192.168.2.1
Node_20(config)#
remote-id 1 remote-ip 192.168.1.1
Example 2
To set up an area virtual link to a remote site (assuming IP connectivity between
the sites already), one site must run the following commands:
SiteA#
SiteA(config)#
remote-id 10 remote-ip 192.168.200.1 remote-area SiteB-AREA
The second site must run the following commands:
SiteB#
SiteB(config)#
remote-id 5 remote-ip 192.168.100.1 remote-area SiteA-AREA
Before you can apply the above atmf virtual-link command, you must configure
the area names SiteB-AREA and SiteA-AREA.
Validation
show atmf
Command
show atmf links
C613-50077-01 REV A
™ (AMF) C
RAMEWORK
OMMANDS
: AMF cannot achieve zero touch replacement of the remote device that
AMF virtual-link id ip remote-id remote-ip (Example)
AMF
Local Site
(subnet 192.168.1.0)
IP Header
UDP Header
Switch 1
AMF Node 10
192.168.1.1
Tunnel ID = 1
Tunnel remote ID = 2
192.168.1.1
atmf virtual-link id 1 ip 192.168.1.1
atmf virtual-link id 2 ip 192.168.2.1
configure terminal
atmf virtual-link id 5 ip 192.168.100.1
configure terminal
atmf virtual-link id 10 ip 192.168.200.1
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Router 1
IP Network
Tunnelled Packet
AMF
Remote Site
(subnet 192.168.2.0)
Router 2
Switch 2
AMF Node 20
192.168.2.1
192.168.2.1
Tunnel ID = 2
Tunnel remote ID = 1
atmf virtual-link ID and IP (Example1).eps
1744

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents