Probe Packets - Allied Telesis AT-AR3050S Command Reference Manual

D H C
YNAMIC OST ONFIGURATION

PROBE PACKETS

probe packets
Overview Use this command to specify the number of packets sent for each lease probe.
Lease probing is configured on a per-DHCP pool basis. When set to 0 probing is
effectively disabled.
The no variant of this command sets the number of probe packets sent to the
default of 5.
probe packets <0-10>
Syntax
no probe packets
Default The default is 5.
Mode DHCP Pool Configuration
To set the number of probe packets to 2 for pool P2, use the commands:
Examples
awplus#
awplus(config)#
awplus(dhcp-config)#
To set the number of probe packets to the default 5 for pool P2, use the
commands:
awplus#
awplus(config)#
awplus(dhcp-config)#
Related probe enable
Commands
probe timeout
probe type
show ip dhcp pool
C613-50077-01 REV A
P (DHCP) C
ROTOCOL OMMANDS
Parameter
<0-10>
configure terminal
ip dhcp pool P2
configure terminal
ip dhcp pool P2
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
The number of probe packets sent.
probe packets 2
no probe packets
1848