Dhcp For Ipv6 (Dhcpv6) Commands; Introduction - Allied Telesis AT-AR3050S Command Reference Manual

38

Introduction

Overview This chapter provides an alphabetical reference for commands used to configure
DHCPv6. For more information, see the
Configuration
DHCPv6 is a network protocol used to configure IPv6 hosts with IPv6 addresses and
IPv6 prefixes for an IPv6 network. DHCPv6 is used instead of SLAAC (Stateless
Address Autoconfiguration) at sites where centralized management of IPv6 hosts
is needed. IPv6 routers require automatic configuration of IPv6 addresses and IPv6
prefixes.
DHCPv6 Prefix Delegation provides automatic configuration of IPv6 addresses and
IPv6 prefixes.
Note that DHCPv6 client does not support tunnel interface.
For information on filtering and saving command output, see "Controlling "show"
Command Output" in the
and Configuration
NOTE
3849 for documentation purposes. These addresses should not be used for practical
networks (other than for testing purposes) nor should they appear on any public
network.
Command List •
•
•
•
•
•
•
•
C613-50077-01 REV A
Guide.
"Getting Started with AlliedWare Plus" Feature Overview
Guide.
: The IPv6 addresses shown use the address space 2001:0db8::/32, defined in RFC
"address prefix" on page 1876
"address range" on page 1878
"clear counter ipv6 dhcp-client" on page 1880
"clear counter ipv6 dhcp-server" on page 1881
"clear ipv6 dhcp binding" on page 1882
"clear ipv6 dhcp client" on page 1884
"dns-server (DHCPv6)" on page 1885
"domain-name (DHCPv6)" on page 1887
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
DHCP for IPv6
(DHCPv6)
Commands
DHCPv6 Feature Overview and
1874