Ipv6 Dhcp Client Pd - Allied Telesis AT-AR3050S Command Reference Manual

DHCP IP 6 (DHCP 6) C
FOR V V OMMANDS
6
IPV DHCP CLIENT PD

ipv6 dhcp client pd

Overview Use this command in Interface Configuration mode to enable the DHCPv6 client
process and enable requests for prefix delegation through the interface that you
are configuring.
Use the no variant of this command to disable requests for prefix delegation. This
is the default setting.
For further information about DHCPv6 Prefix Delegation, which is used to
automate the process of assigning prefixes, see the
Configuration
ipv6 dhcp client pd <prefix-name>
Syntax
no ipv6 dhcp client pd
Mode Interface Configuration
Default Prefix delegation is disabled by default on an interface.
Usage Entering the ipv6 dhcp client pd command starts the DHCPv6 client process if
not already running, and enables requests for prefix delegation through the
interface on which the command is configured.
When prefix delegation is enabled and a prefix is acquired, the prefix is stored in
the IPv6 prefix pool with an internal name defined by the required <prefix-name>
placeholder parameter. The
stored in the IPv6 prefix pool.
Examples To enable prefix delegation with the prefix name prefix-name on the VLAN
interface vlan2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To disable prefix delegation on the VLAN interface vlan2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50077-01 REV A
Guide.
Parameter
<prefix-name>
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
Specify an IPv6 general prefix name. Valid characters are any
printable character. If the name contains spaces then you
must enclose it in "quotation marks".
ipv6 address command can then refer to the prefixes
ipv6 enable
ipv6 dhcp client pd my-prefix-name
no ipv6 dhcp client pd
DHCPv6 Feature Overview and
1894