Interface Tunnel - Allied Telesis AT-AR3050S Command Reference Manual

GRE T C
UNNELING OMMANDS

INTERFACE TUNNEL

interface tunnel
Overview Use this command to create a tunnel interface. Tunnel interfaces are identified by
an index identifier that is an integer in the range from 0 through 255. Note that the
tunnel mode command is needed to enable the tunnel.
Use the no variant of this command to remove a previously created tunnel
interface.
interface tunnel<0-255>
Syntax
no interface tunnel<tunnel-index>
Default Tunnel interfaces do not exist.
Mode Global Configuration
Usage This command creates a new tunnel interface to configure in Global Configuration
mode.
This command is also used to enter Interface Configuration mode for existing
tunnel interfaces.
To configure a tunnel interface with index 30 and enable GRE, use the commands:
Examples
awplus#
awplus(config)#
awplus(config-if)#
To remove the GRE tunnel interface tunnel30, use the commands:
awplus#
awplus(config)#
C613-50077-01 REV A
Parameter Description
<0-255>
Specify a tunnel interface index identifier in the range
from 0 through 255.
configure terminal
interface tunnel30
configure terminal
no interface tunnel30
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
tunnel mode gre
2324