Tunnel Protection Ipsec (Ipsec) - Allied Telesis AT-AR3050S Command Reference Manual

IP C
SEC OMMANDS
(IP
TUNNEL PROTECTION IPSEC SEC

tunnel protection ipsec (IPsec)

Overview Use this command to enable IPsec protection for packets encapsulated by this
tunnel.
Use the no variant to disable IPsec protection.
Syntax tunnel protection ipsec [profile <profile_name>]
no tunnel protection ipsec
Default IPsec protection for packets encapsulated by tunnel is disabled. If no custom
profile is specified, the default profile is used.
Mode Interface Configuration
Usage IPsec mode tunnels (IPv4 and IPv6) require this command for them to work. GRE
IPv6 and L2TPv3 IPv6 tunnel have IPsec protection as an option.
Examples To enable IPsec protection by using default profile, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To enable IPsec protection by using a custom profile, use the following commands:
awplus(config)#
awplus(config-if)#
my_profile
To disable IPsec protection for packets encapsulated by tunnel14, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related crypto ipsec profile
Commands
C613-50077-01 REV A
)
Parameter
<profile_name>
configure terminal
interface tunnel14
interface tunnel14
configure terminal
interface tunnel14
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
Custom profile name. You can use the
command to create custom profiles.
tunnel protection ipsec
tunnel protection ipsec profile
no tunnel protection ipsec
crypto ipsec profile
2313