Allied Telesis AT-AR3050S Command Reference Manual page 1735

A T M F
LLIED ELESIS ANAGEMENT
-
ATMF REBOOT ROLLING
Several checks are performed to ensure the upgrade will succeed. These include
checking the current node release boots from flash. If there is enough space on
flash, the software release is copied to flash to a new location on each node as it is
processed. The new release name will be updated using the boot
system<release-name> command, and the old release will become the backup
release file.
NOTE
then the URL should specify the exact release filename without using wild card
characters.
On bootup the software release is verified. Should an upgrade fail, the upgrading
unit will revert back to its previous software version. At the completion of this
command, a report is run showing the release upgrade status of each node.
NOTE
an external media while files are being written entails a significant risk of causing a file
corruption.
Example 1 To reboot all x510 nodes in an AMF network, use the following command:
Bld2_Floor_1#
This command returns the following type of screen output:
ATMF_NETWORK[3]#
When the reboot has completed, a number of status screens appear. The selection
of these screens will depend on the parameters set.
C613-50077-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
: If you are using TFTP or HTTP, for example, to access a file on a remote device
: Take care when removing external media or rebooting your devices. Removing
atmf working-set group x510
===================
node1, node2, node3:
=====================

Working set join

AMF_NETWORK[3]#
atmf reboot-rolling
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
1735