Move Rule (Nat) - Allied Telesis AT-AR3050S Command Reference Manual

NAT C
OMMANDS
(NAT)
MOVE RULE

move rule (NAT)

Overview Use this command to change the order of a NAT rule.
You can move an existing rule ID only to an ID that is not assigned to any rule,
otherwise you will receive an error message.
Syntax move rule <1-65535> to <1-65535>
Mode NAT Configuration
To change the ID of a rule from 10 to 30, use the commands:
Examples
awplus#
awplus(config)#
awplus(config-nat)#
Validation show nat rule
commands
show running-config nat
Related rule (NAT)
commands
C613-50077-01 REV A
Parameter
move rule
<1-65535>
to <1-65535>
configure terminal
nat
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
Move the order of a given rule. The rule ID of the given rule
must exist.
Each rule has an ID which is either designated by the user or
automatically generated when the rule is created. The rule
ID is an integer from 1 to 65535.
New rule ID to assign. The new rule ID must not be used by
any existing rule.
move rule 10 to 30
2160