Deadtime (Radius Server Group) - Allied Telesis AT-AR3050S Command Reference Manual

Next-generation firewall
Hide thumbs Also See for AT-AR3050S:
Table of Contents

Advertisement

RADIUS C
OMMANDS
(RADIUS
DEADTIME
SERVER GROUP

deadtime (RADIUS server group)

Overview
Use this command to configure the deadtime parameter for the RADIUS server
group. This command overrides the global dead-time configured by the
radius-server deadtime
minutes to skip a RADIUS server for authentication or accounting requests if the
server is "dead". Note that a RADIUS server is considered "dead" if there is no
response from the server within a defined time period.
Use the no variant of this command to reset the deadtime configured for the
RADIUS server group. If the global deadtime for RADIUS server is configured the
value will be used for the servers in the group. The global deadtime for the RADIUS
server is set to 0 minutes by default.
deadtime <0-1440>
Syntax
no deadtime
Default
The deadtime is set to 0 minutes by default.
Mode
Server Group Configuration
Usage
If the RADIUS server does not respond to a request packet, the packet is
retransmitted the number of times configured for the retransmit parameter (after
waiting for a timeout period to expire). The server is then marked "dead", and the
time is recorded. The deadtime parameter configures the amount of time to skip
a dead server; if a server is dead, no request message is sent to the server for the
deadtime period.
Examples
To configure the deadtime for 5 minutes for the RADIUS server group "GROUP1",
use the command:
awplus(config)#
awplus(config-sg)#
awplus(config-sg)#
To remove the deadtime configured for the RADIUS server group "GROUP1", use
the command:
awplus(config)#
awplus(config-sg)#
Related
aaa group server
Commands
radius-server deadtime
C613-50077-01 REV A
)
Parameter
Description
<0-1440>
Amount of time in minutes.
aaa group server radius GROUP1
aaa group server radius GROUP1
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
command. The configured deadtime is the time period in
server 192.168.1.1
deadtime 5
no deadtime
1576

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents