Debug Atmf Packet - Allied Telesis AT-AR3050S Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

DEBUG ATMF PACKET

debug atmf packet
Overview This command configures AMF Packet debugging parameters. The debug only
displays information relevant to the current node. The command has following
parameters:
debug atmf packet[[direction {rx|tx|both}][level
Syntax
{1|2|3}][timeout <seconds>][num-pkts <quantity>][filter node
<name> [interface <ifname>][pkt-type
{[1][2][3][4][5][6][7][8][9][10][11][12][13]]]
Simplified
Syntax
debug atmf packet
debug atmf packet
NOTE
retain their original order.
Default Level 1, both Tx and Rx, a timeout of 60 seconds with no filters applied.
NOTE
elsewhere in this chapter.
Mode User Exec and Global Configuration
Usage If no additional parameters are specified, then the command output will apply a
default selection of parameters shown below:
C613-50077-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
[direction {rx|tx|both}]
[level {[1][2|3}]
[timeout <seconds>]
[num-pkts <quantity>]
filter [node <name>]
[interface <ifname>]
[pkt-type
[1][2][3][4][5][6][7][8][9][10][11][12][13]]
: You can combine the syntax components shown, but when doing so, you must
: An alias to the no variant of this command -
Parameter Description
direction
Sets debug to packet received, transmitted, or both
rx
packets received by this node
tx
Packets sent from this node
1
AMF Packet Control header Information, Packet Sequence
Number. Enter 1 to select this level.
2
AMF Detailed Packet Information. Enter 2 to select this level.
3
AMF Packet HEX dump. Enter 3 to select this level.
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
undebug atmf - can be found
1750