Nat - Allied Telesis AT-AR3050S Command Reference Manual

NAT C
OMMANDS

NAT

nat
Overview Use this command to configure NAT.
Use the no variant of this command to remove all NAT configuration.
Syntax nat
no nat
Mode Global Configuration
Usage This command allows you to enter the NAT Configuration mode. The command
prompt for this mode is awplus(config-nat)#.
In the NAT Configuration mode, you can:
•
•
Examples To configure NAT, use the commands:
awplus#
awplus(config)#
awplus(config-nat)#
To remove all NAT configuration, use the commands:
awplus#
awplus(config)#
Validation show nat
commands
C613-50077-01 REV A
Enable NAT, see the enable (NAT)
Create NAT rules or change the order of NAT rules, see the
command and the move rule (NAT)
configure terminal
nat
configure terminal
no nat
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
command.
command.
rule (NAT)
2161