Tunnel Destination (Gre) - Allied Telesis AT-AR3050S Command Reference Manual

GRE T C
UNNELING OMMANDS
(GRE)
TUNNEL DESTINATION

tunnel destination (GRE)

Overview Use this command to specify a tunnel destination for the remote end of the tunnel.
Tunnel destination can be specified by using a destination network name or an
IPv4 address.
Use the no variant of this command to remove a configured tunnel destination.
Syntax tunnel source {<ipv4-addr>|<destination-network-name>}
no tunnel destination
Mode Interface Configuration
Examples To configure an IPv4 tunnel destination by using an IPv4 address, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To configure a GRE tunnel destination by using a destination network name, use
the commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
corporate_lan.example.com
To remove a GRE tunnel destination, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50077-01 REV A
Parameter Description
<ipv4-addr>
Specify the tunnel destination IPv4 address in the dotted decimal
format A.B.C.D.
The endpoints of the tunnel must be configured by mirroring IP
addresses, that is, the tunnel source on one endpoint must be
specified as the tunnel destination on the other endpoint.
<destination
Destination network name.
-
If the destination network name cannot be resolved, then the GRE
network-name
tunnel remains inactive.
>
configure terminal
interface tunnel40
configure terminal
interface tunnel40
configure terminal
interface tunnel40
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
tunnel mode gre
tunnel destination 2.2.2.2
tunnel mode gre
tunnel destination
no tunnel destination
2337