Snmp-Server Source-Interface - Allied Telesis AT-AR3050S Command Reference Manual

SNMP C
OMMANDS
- -
SNMP SERVER SOURCE INTERFACE

snmp-server source-interface

Overview Use this command to specify the originating interface for SNMP traps or informs.
An interface specified by this command must already have an IP address assigned
to it.
Use the no variant of this command to reset the interface to its default value (the
originating egress interface).
snmp-server source-interface {traps|informs} <interface-name>
Syntax
no snmp-server source-interface {traps|informs}
Default By default, the source interface is the originating egress interface of the traps and
informs messages.
Mode Global Configuration
Usage An SNMP trap or inform message that is sent from an SNMP server carries the
notification IP address of its originating interface. Use this command to assign this
interface.
Example The following commands set VLAN20 to be the interface whose IP address is used
as the originating address in SNMP informs packets.
awplus#
awplus(config)#
The following commands reset the originating source interface for SNMP trap
messages to be the default interface (the originating egress interface):
awplus#
awplus(config)#
Validation show running-config
Commands
C613-50077-01 REV A
Parameter
traps
informs
<interface-name> Interface name (must already have an IP address assigned).
configure terminal
snmp-server source-interface informs vlan20
configure terminal
no snmp-server source-interface traps
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
SNMP traps.
SNMP informs.
1974