Dpd-Timeout - Allied Telesis AT-AR3050S Command Reference Manual

IP C
SEC OMMANDS
-
DPD TIMEOUT

dpd-timeout

Overview Use this command to specify a Dead Peer Detection (DPD) timeout for IKEv1.
DPD is an IKE mechanism using a form of keep-alive to determine if a tunnel peer
is still active.
DPD timeout defines the timeout interval after which all connections to a peer are
deleted in case of inactivity. This only applies to IKEv1, in IKEv2 the default
retransmission timeout applies as every exchange is used to detect dead peers.
Use the no variant to set the timeout to its default (150 seconds).
dpd-timeout <10-86400>
Syntax
no dpd-timeout
Default If you do not specify a timeout, the default timeout of 150 seconds applies.
Mode ISAKMP Profile Configuration
Examples To specify a DPD timeout for IKEv1, use the following commands:
awplus(config)#
awplus(config-isakmp-profile)#
To set the timeout to its default, use the following command:
awplus(config-isakmp-profile)#
Related crypto isakmp profile
Commands
Related show isakmp profile
Commands
C613-50077-01 REV A
Parameter Description
<10-86400>
Timeout in seconds.
crypto isakmp profile my_profile
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
dpd-timeout 200
no dpd-timeout
2282