Trap - Allied Telesis AT-AR3050S Command Reference Manual

T C
RIGGER OMMANDS

TRAP

trap
Overview This command enables the specified trigger to send SNMP traps.
Use the no variant of this command to disable the sending of SNMP traps from the
specified trigger.
Syntax trap
no trap
Default SNMP traps are enabled by default for all defined triggers.
Mode Trigger Configuration
Usage You must configure SNMP before using traps with triggers. For more information,
see:
•
•
Since SNMP traps are enabled by default for all defined triggers, a common usage
will be for the no variant of this command to disable SNMP traps from a specified
trap if the trap is only periodic. Refer in particular to AT-TRIGGER-MIB in the
MIBs Overview
Examples To enable SNMP traps to be sent from trigger 5, use the commands:
awplus#
awplus(config)#
awplus(config-trigger)#
To disable SNMP traps being sent from trigger 205, use the commands:
awplus#
awplus(config)#
awplus(config-trigger)#
Related trigger
Commands
show trigger
C613-50077-01 REV A
the SNMP MIBs Overview, for information about which MIB objects are
supported.
the SNMP Feature Overview and Configuration
for further information about the relevant SNMP MIB.
configure terminal
trigger 5
configure terminal
trigger 205
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Guide.
trap
no trap
SNMP
2056