Area Nssa (Router Ospf) - Dell Networking 7048 Reference Manual

integer — The default cost for the stub area. (Range: 1–16777215)
•
Default Configuration
integer
10 is the default configuration for .
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example identifies a stub area of 10 and default cost of 100.
console(config)#router ospf
console(config-router)#area 10 default-cost 100

area nssa (Router OSPF)

Use the area nssa command in Router OSPF Configuration mode to
configure the specified area ID to function as an NSSA. If the area has not
been previously created, this command creates the area and then applies the
NSSA distinction. If the area already exists, the NSSA distinction is added or
modified. Use the no form of the command to remove the NSSA distinction
from the specified area ID.
Syntax
area-id
area nssa [no-redistribution] [default-information-originate [metric
metric-value metric-type-value
] [metric-type ]] [no-summary] [translator-
role role] [translator-stab-intv interval]
area-id
no area nssa [no-redistribution] [default-information-originate] [no-
summary] [translator-role] [translator-stab-intv]
1150
OSPF Commands