Show Ipv6 Route - Dell Networking 7048 Reference Manual

Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays information about the IPv6 neighbors.
console(config)#show ipv6 neighbors
Neighbor Last
IPv6 Address
-------------------- ----------------- -----

show ipv6 route

Use the show ipv6 route command in User EXEC or Privileged EXEC mode
to display the IPv6 routing table. The output of the command also displays
the IPv6 address of the default gateway and the default route associated with
the gateway.
Syntax
show ipv6 route [ipv6-address | ipv6-prefix/prefix-length | protocol |
interface-type interface-number] [best]
Syntax Description
Parameter
ipv6-address
protocol
ipv6-prefix/ prefix-
length
MAC Address
Description
Specifies an IPv6 address for which the best-matching route
would be displayed.
Specifies the protocol that installed the routes. Is one of the
following keywords: connected, ospf, static.
Specifies an IPv6 network for which the matching route would
be displayed.
isRtr State
------- ---------
IPv6 Routing Commands
Updated
Interface
1101