Ip Mroute - Dell Networking 7048 Reference Manual

Syntax
ip mcast boundary
no ip mcast boundary
groupipaddr — IP address of multicast group. Valid range is 239.0.0.0 to
•
239.255.255.255.
mask — IP mask of multicast group.
•
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds an administrative scope multicast boundary.
console(config)#interface vlan 15
console(config-if-vlan15)#ip mcast boundary 239.5.5.5 255.255.255.255

ip mroute

Use the ip mroute command to create a static multicast route for a source
range. Use the no form of this command to delete a static multicast route.
Syntax
source-address mask rpf-address preference
ip mroute
source-address mask
no ip mroute
source-address — The IP address of the multicast data source.
•
mask — The IP subnet mask of the multicast data source.
•
rpf-address — The IP address of the next hop towards the source.
•
preference — The cost of the route (Range: 1 - 255).
•
groupipaddr mask
groupipaddr mask
Multicast Commands
1117