Ip Pim Bsr-Candidate - Dell Networking 7048 Reference Manual

ip pim bsr-candidate

The ip pim bsr-candidate command is used to configure the router to
advertise itself as a bootstrap router (BSR). Use the no form of this command
to return to the default configuration. This command replaces the ip pimsm
bsr-candidate, ip pimsm cbsrhaskmasklength and ip pimsm cbsrpreference
commands.
Syntax
ip pim bsr-candidate vlan {
interval
]}
no ip pim bsr-candidate vlan {
Parameter Description
Parameter
vlan-id
hash-mask-length
bsr-priority
interval
Default Configuration
None - the router does not advertise itself as a BSR candidate.
Command Mode
Global Configuration mode
User Guidelines
All multicast groups with the same hash value correspond to the same RP .
Lower priority values are preferred.
1122
Multicast Commands
vlan-id hash-mask-length bsr-priority
vlan-id}
Description
A valid VLAN identifier with multicast routing enabled.
Length of the BSR hash to be
group address. (Range 0–32 bits). Default 0.
The advertised priority of the BSR candidate. Range 0-255.
Default 0.
(Optional) Indicates the RP candidate advertisement interval.
The range is from 1 to 16383 seconds. The default value is 60
seconds.
ANDed with the multicast
[interval