Show Ip Multicast; Ip Pim Ssm - Dell Networking 7048 Reference Manual

ip pim ssm

Use the ip pim ssm command in Global Configuration mode to
administratively configure PIM source specific multicast range of addresses
for IP multicast routing. Use the no form of this command to remove
configured ranges of addresses from the router.
Syntax
ip pim ssm {default |
no ip pim ssm {default |
Parameter Description
Parameter
default
group-address
group-mask
Default Configuration
There are no group addresses configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip pim ssm 239.0.10.0 255.255.255.0

show ip multicast

Use the show ip multicast command in Privileged EXEC mode to display the
system-wide multicast information.
group-address group-mask
group-address group-mask
Description
Defines the SSM range access list to 232/8.
An IP multicast group address.
An IPv4 mask in a.b.c.d form where a, b, c and d range from 0-
255.
}
}
Multicast Commands
1129