Set Macauthentication Port - Enterasys Matrix 2G4072-52 Configuration Manual

14.3.7.8

set macauthentication port

Use this command to enable or disable one or more ports for MAC authentication.
set macauthentication port {enable | disable} port-string
NOTE: Enabling port(s) for MAC authentication requires globally enabling MAC
authentication on the device as described in
port-by-port basis. By default, MAC authentication is globally disabled and disabled on
all ports.
Syntax Description
enable | disable
port-string
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to enable MAC authentication on ge.2.1 though 5:
Matrix(rw)->set macauthentication port enable ge.2.1-5
Enables or disables MAC authentication.
Specifies port(s) on which to enable or disable MAC
authentication. For a detailed description of possible
port-string values, refer to
Matrix DFE-Platinum and Diamond Series Configuration Guide
Security Configuration Command Set
Configuring MAC Authentication
Section 14.3.7.3, and then enabling it on a
Section 4.1.1.
14-89