Icmp Echo - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IP Commands

icmp echo

Enables or disables ICMP echo messages, and sets the minimum packet gap. The minimum packet gap is
the number of microseconds that must pass between ICMP messages of the same type.
icmp echo [request | reply] {{enable | disable} | min-pkt-gap gap}
Syntax Definitions
request
reply
enable
disable
gap
Defaults
parameter
enable | disable
gap
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
This command sets the ICMP echo messages. An echo request is sent to a destination, and must be
responded to with an echo reply message that contains the original echo request.
•
Using this command without specifying a request or reply will enable, disable, or set the minimum
packet gap for both types.
•
The echo ICMP messages can also be enabled, disabled, and modified using the
See the icmp type
Examples
-> icmp echo reply enable
-> icmp echo enable
-> icmp echo request enable
-> icmp echo request min-pkt-gap 50
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Specifies the echo request ICMP message.
Specifies the echo reply ICMP message.
Enables the specified ICMP message.
Disables the specified ICMP message.
The number of microseconds required between ICMP messages of this
type.
default
enable
0
command information on the type and code for the echo ICMP messages.
June 2012
icmp type command.
page 14-85