Show Ip Redist - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip redist

Displays the IPv4 route map redistribution configuration.
show ip redist [rip | ospf | bgp]
Syntax Definitions
rip
ospf
bgp
Defaults
By default all route map redistribution configurations are shown.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
Specify a destination protocol with this command to display only those configurations that redistribute
routes into the specified protocol.
Release History
Release 6.1.3; command was introduced.
Examples
-> show ip redist
Source Destination
Protocol Protocol
------------+------------+---------+--------------------
RIP OSPF
BGP RIP
-> show ip redist rip
Source Destination
Protocol Protocol
------------+------------+---------+--------------------
BGP RIP
page 14-114
Displays route map redistribution configurations that use RIP as the
destination (into) protocol.
Displays route map redistribution configurations that specify OSPF as
the destination (into) protocol.
Displays the route map redistribution configurations that specify BGP as
the destination (into) protocol at this time.
Status Route Map
Enabled ipv4rm
Enabled ipv4rm
Status Route Map
Enabled ipv4rm
OmniSwitch CLI Reference Guide
IP Commands
June 2012