Data Disks; Disk Position - Nortel Meridian 1 Manual

Data disks

Check the disk identification to make sure it is the correct disk. Compare
software options with the data cartridge. Follow these precautions to avoid
damaging disks:
— Handle only the hard surface; never touch the recording surface.
— Keep disks away from strong magnetic fields.
— Avoid exposing disks to extreme heat, rapid changes in temperature, or
high humidity.
— Store disks in a suitable container.
To install a disk, make sure the arrow on the label is pointing up and the
rounded corner is on the bottom on the right-hand side (see Figure 2).
The disk drive can be damaged if an upside-down disk is forced into
the slot. If there is significant resistance when you try to insert a disk,
remove the disk and check the position.
Figure 2

Disk position

CAUTION
Top — arrow pointing up
Bottom — rounded corner
Introduction Page 7 of 500
Insert in
this direction
553-5001
553-5001
System installation procedures