Honda Accord 2008 Manual page 674

07/11/02 09:17:57 61TA0000_110_0355
20. Connect ECM/PCM connector terminal A7 to body
ground with a jumper wire.
＊０９
21. Turn the ignition switch to ON (II).
22. Measure voltage between ECM/PCM connector
terminal A16 and body ground.
＊１０
Is there battery voltage?
YES
NO −
23. Turn the ignition switch to LOCK (0).
24. Reconnect ECM/PCM connector A (49P).
ECM/PCM CONNECTOR A (49P)
MRLY (RED/BLK)
JUMPER WIRE
Terminal side of female terminals
ECM/PCM CONNECTOR A (49P)
IMOFPR (GRY)
Terminal side of female terminals
−
Go to step 23.
Replace PGM-FI main relay 2 (FUEL PUMP).
25. Turn the ignition switch to ON (II), and measure
voltage between driver's under-dash fuse/relay box
connector F (33P) terminal No. 22 and body ground
within 2 seconds.
DRIVER'S UNDER-DASH FUSE/RELAY BOX
CONNECTOR F (33P)
IMOFPR (GRY)
Wire side of female terminals
Is there battery voltage?
−
YES Update the ECM/PCM if it does not have the
latest software (see page 11-231), or substitute a
known-good ECM/PCM (see page 11-7), then
recheck. If the symptom/indication goes away with
a known-good ECM/PCM, replace the original ECM/
PCM (see page 11-232).
NO − Go to step 26.
＊１１
(cont'd)
11-355