Chapter 15
Editing an AppleTalk Zone Filter
Using the Web
Agent
Using the CLI
15-22
You can edit an AppleTalk zone filter using either the Web Agent or
the CLI.
To edit an AppleTalk zone filter using the Web Agent:
1. Select Zone Filter from the Routing > AppleTalk >
Configuration group on the Web Agent window. The
AppleTalk Zone Filter dialog box opens (Figure 15-18).
2. Click the checkbox in the Select column next to the
AppleTalk zone filter that you want to be edit.
3. Refer to Table 15-4 to edit the AppleTalk Zone Filter dialog
box parameters:.
4. Click:
CREATE to add a new zone filter. The Add AppleTalk
—
Zone Filter dialog box opens. See "Creating an
AppleTalk Zone Filter", earlier in this section for more
information.
DELETE to remove the selected zone filter.
—
CANCEL to restore previous settings.
—
Edit If to add or delete this zone filter to/from an
—
interface. The Add/Delete Interface to Zone Filter
dialog box opens. See "Adding or Deleting Interfaces to a
Zone Filter", later in this section for more information.
To edit an AppleTalk zone filter using the CLI, enter the following
command from Interface mode:
(config-if <interface-name>:)# appletalk access-
list <access-list-number> <permit | deny> zone
<string>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3.1 for details about this command.
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1