CLI Command
Creating IPX SAP Filters
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Table 14-1. IPX SAP Interface Dialog Box Parameters continued
Parameter
Get Nearest Server
Reply
Get Nearest Server
Reply Delay(msec.)
Mode
3. Click APPLY to save your changes, or CANCEL to restore
previous settings.
To configure the IPX SAP interfaces using the CLI, enter the
following command from Interface mode:
(config-if <interface-name>):# ipx sap
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
This section provides the following procedures:
Creating IPX SAP Name Filters
Creating IPX SAP Network Filters
Configuring the IPX SAP Protocol
Allows you to...
Select one of the following from the pull-down
menu:
• Disable – To prevent the router from
responding to Get Nearest Server requests
received on the interface
• Enable – To allow the router to respond to
Get Nearest Server requests received on
the interface (default).
Specify the delay (in msecs) to wait before
responding to a Get Nearest Service request
received on the interface.Default is 0.
Select one of the following from the pull-down
menu:
• Talk/Listen - Send and receive
advertisements (default).
• Talk Only - Send advertisements.
• Listen Only - Receive advertisements.
14-3