Avaya Cajun P882 User Manual page 167

Adding Switch
Ports to the
Hunt Group
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
Using VLANs, Spanning Tree, Hunt Groups, and VTP Snooping
Figure 4-21. Physical Port Configuration Window
3. Uncheck the checkbox from the Enable column for a specific
port. The check mark disappears to disable the port.
* Note: Check the speed of the ports that you are configuring
into the Hunt Group. The ports must be physically
connected to each other (for example, in a four-port
Gigabit hunt group, ensure that you have four fiber
cables with switch ports connected at each end).Also
Auto-negotiation should be disabled on the ports to
further insure against speed mismatch
If this is a new hunt group, disable all of the ports you are
—
adding to the hunt group.
If you are adding ports to an existing hunt group, disable
—
the ports you are adding.
4. Click APPLY to save your changes, or CANCEL to restore
previous settings.
1. Select Modules at the bottom of the Physical Port
Configuration dialog box. The Module Information dialog
box re-opens.(Figure 4-20). As an alternate procedure, select
Configuration > Modules and Ports > Module Information
window.
2. Select a number from the Switch Ports column, for the
module whose port(s) you are adding to the hunt group. The
Switch Ports dialog box opens (Figure 4-22).
4-37