Avaya Cajun P882 User Manual page 251

Multiservice switch

Hide thumbs Also See for Cajun P882:

Table of Contents

CLI Commands

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1

To enable traps for unknown source addresses, you must first enable

the MAC Address Lock feature. You can enable this feature and

traps for unknown source addresses by using the Web Agent, CLI, or

To use the Web Agent to enable the MAC Address Lock feature and

traps for unknown source addresses:

1. Manually add the "permitted" MAC addresses to the Address

Forwarding Table (AFT).

For information on how to manually add MAC address to the

AFT, see "Adding Entries to the AFT Manually" on page 19.

2. Open the Switch Port Configuration Web page for the port.

For information on how to open this Web page, see

"Configuring Switch Port Parameters" on page 23.

3. Set the Allow Learning field to Disable.

4. Set the Known Mode field to Enable.

* Note: To prevent the flooding of frames that have

unknown destination addresses, set the Known

Mode field to Enable for all ports on the same

VLAN as the port for which you are enabling

MAC address lock.

5. Set the Intrusion Trap field to Enable.

6. Adjust the trap timer, if desired.

For information on how to adjust the trap timer, see

"Configuring Switch Port Parameters" on page 23.

7. Click Apply.

To use the CLI to enable the MAC Address Lock feature and traps for

unknown source addresses:

1. Enter Global Configuration mode.

The CLI displays the Avaya (configure)# prompt.

2. Use the following command to manually add the "permitted"

MAC addresses to the Address Forwarding Table (AFT):

set aft entry <mac address> VLAN <VLAN-id> port-

binding forward <mod-port-spec>

Managing the Address Forwarding Table

P550r P580 P880