Avaya Cajun P882 User Manual page 593

CLI Command
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Monitoring and Configuring the Forwarding Cache
Table 18-1. Layer-3 Forwarding Cache Configuration Dialog Box
Parameters for Tree Configuration
Tree Configuration
Field... For the
protocol...
Hash Mode IP Unicast
(IPU)
IP Multicast
(IPM)
IPX
Aging IP Unicast
IP Multicast
IPX
Age IP Unicast
Interval
IP Multicast
IPX
Maximum IP Unicast
Entries
IP Multicast
IPX
3. Click:
APPLY to save your changes
—
CANCEL to restore previous settings
—
REFRESH to update your system configuration
—
CLEAR to reset all configuration parameters to zero.
—
To configure the forwarding cache using the CLI, enter the following
command from Configure mode:
<configure># ip multicast route-cache <options>
<configure># ip unicast route-cache <options>
Allows you to...
Configure the table hash lookup mode for
the IP unicast, IP multicast and IPX
protocols. The options are:
• DA-only - Forwarding entries
input to the forwarding table are
limited to using protocol destination
address only.
• SA-DA - Forwarding entries input
to the forwarding table are limited
to using destination and source
address only.
Configure the IP unicast, IP multicast, or
IPX protocols forwarding table entry
aging status as either Enable (default)
or Disable.
The IP unicast, IP multicast, or IPX
protocols forwarding table entry aging
period (in seconds). The valid range is 20-
360 seconds. The default value is 120
seconds.
The number of active entries in the IP
unicast, IP multicast, or IPX protocol
forwarding table. This is the maximum
number of active entries per fabric port.
Additional flows are forwarded by the
supervisor module. The default value is
15000.
18-3