Avaya Cajun P882 User Manual page 624

Multiservice switch

Hide thumbs Also See for Cajun P882:

Table of Contents

CLI Commands

To use the CLI to enable the MAC Address Lock feature and traps for

unknown source addresses:

1. Enter Global Configuration mode.

The CLI displays the <configure># prompt.

2. Use the following command to manually add the "permitted"

MAC addresses to the Address Forwarding Table (AFT):

set aft entry <mac address> vlan <vlan-id> port-binding

forward <mod-port-spec>

3. Use the following command to disable learning on a port or

set port allow-learning <mod-swport-range> disable

4. Use the following command to enable known mode on a port

or port range:

set port known-mode <mod-swport-range> enable

* Note: To prevent the flooding of frames that have

unknown destination addresses, enter all ports

on the same VLAN as the port for which you are

enabling MAC address lock.

5. Use the following command to enable intrusion traps on a

port or port range:

set port intrusion-trap <mod-swport-range> enable

6. Use the following command to set the intrusion trap timer to

other than the default setting:

set port intrusion-trap-timer <mod-swport-range>

<intrusion-trap-timer-value>

The MIB objects that you use to perform this procedure are located

in ProminetMib.txt, version 5.2.

To use SNMP to enable the MAC Address Lock feature and traps for

unknown source addresses:

1. Use the MIB objects that are listed in Table 19-12 to manually

add the "permitted" MAC addresses to the AFT.

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1

P550r P580 P880