Chapter 13 - Configuring The Ipx Rip Protocol; Overview; Configuring Ipx Rip Interfaces - Avaya Cajun P882 User Manual

13

Overview

Configuring IPX RIP Interfaces

Web Agent
Procedure
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Configuring the IPX RIP
Protocol
The information and procedures provided in this chapter pertain to
layer 3 module configuration only. This chapter provides
information about the Internetwork Packet Exchange (IPX) Routing
Interface Protocol (RIP) and procedures for the following tasks:
Configuring IPX RIP Interfaces
Creating and Modifying IPX RIP Filters
You can configure IPX RIP interfaces using either the Web Agent or
the CLI.
To configure IPX RIP interfaces using the Web Agent:
1. Select Interfaces from the Routing > IPX > RIP group on
the Web Agent window. The IPX RIP Interfaces dialog box
opens (Figure 13-1). If no IPX interfaces are presently
configured then the "No Interfaces are currently configured"
message is displayed.
Figure 13-1. IPX RIP Interfaces Dialog Box
13-1