Using the CLI
Creating an AppleTalk Static Route
Using the Web
Agent
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Use the following CLI commands in interface mode to delete an
AppleTalk interface:
(config if-:<interface-name>)# no appletalk cable-range
<cable-range>
(config if-:<interface-name>)# no appletalk address
<network.node>
(config if-:<interface-name>)# no appletalk zone <zone-name>
(config if-:<interface-name>)# no appletalk vlan <vlan-id>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3.1 for details about this command.
You can create an AppleTalk static route using the Web Agent or the
CLI.
To create an AppleTalk static route using the Web Agent:
1. Select Static Route from the Routing > AppleTalk >
Configuration group on the Web Agent window. The
AppleTalk Static Route dialog box opens (Figure 15-8).
Figure 15-8. AppleTalk Static Route Dialog Box
2. Select CREATE to add a new static route. The Add
AppleTalk Static Route dialog box opens (Figure 15-9).
Configuring AppleTalk Routing
15-11