Chapter 4
Creating Hunt
Groups Using
the CLI
Viewing Hunt Group Members
Using the Web
Agent
4-40
10. Select a checkbox from the Enable column for that port. The
group can now function as a load-sharing connection.
11. Click APPLY to save your changes, or CANCEL to restore
previous settings.
* Note: If thousands of addresses have been learned on a port
and a link in the hunt group goes down, the switch-over
of traffic between ports may take several seconds.
* Note: If you use static VLAN binding and hunt groups, make
sure to first bind all the VLANs to all the ports that you
will use in the hunt group and then apply the hunt
group to those ports.
To create a hunt group using the CLI, enter the following command
from Configure mode:
<configure># set huntgroup <huntgroup-name>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
You can view Hunt Group members from either the Web Agent or
the CLI.
To view details about hunt group members using the Web Agent:
1. Select Hunt Groups from the L2 Switching folder in the
Web Agent window. The Hunt Group Configuration
window opens (Figure 4-24).
2. Select a underlined number in the Members column. The
Hunt Group Members window opens with pertinent
information about the members of that hunt group
(Figure 4-24)
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1