Editing Appletalk Interfaces - Avaya Cajun P882 User Manual

Chapter 15

Editing AppleTalk Interfaces

Using the Web
Agent
15-8
(config if-:<interface-name>)# appletalk address
<network.node>
(config if-:<interface-name>)# appletalk zone <zone-name>
(config if-:<interface-name>)# appletalk vlan <vlan-id>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3.1 for details about this command.
You can edit AppleTalk interfaces using either the Web Agent or the
CLI.
To edit an AppleTalk interface using the Web Agent:
* Note: You must enable AppleTalk globally and create an
AppleTalk interface before you can edit an interface. See
"Enabling AppleTalk Global Routing" and "Creating an
AppleTalk Routing Interface", earlier in this section.
1. Select Interfaces from the Routing > AppleTalk >
Configuration group on the Web Agent window. The
AppleTalk Interfaces dialog box opens (Figure 15-6).
2. If there is no zone to select or if you want to edit the zones
available, complete this step through step x. If not, skip to
step x+1. Select Edit Zone to edit the AppleTalk zone for this
interface. The Edit AppleTalk Zone dialog box opens
(Figure 15-5).
Figure 15-5. Edit AppleTalk Zone Dialog Box
3. To add a new zone, enter the new AppleTalk zone name in
the Add text field and click Add. Repeat this step as needed
for each new zone on this interface.
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1