Chapter 5
CLI Command
GBIC Identification
Web Agent
Procedure
5-38
To view switch port parameters using the CLI, enter the following
command from Priv mode:
> show port [{<mod-num>|<mod-swport-range>}
[...,{<mod-num>|<mod-swport-range>}]]
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for more details about this
command.
The GBIC Identification feature identifies the type of GBICs that are
installed in 80-series gigabit modules with GBIC interfaces. The
feature identifies the following types of connectors:
GBIC SX (short wavelength)
GBIC LX (long wavelength)
GBIC LX/LH (long wavelength/long haul)
If any nonstandard connectors are present, the feature identifies
them as GBIC LX/LH. You can view this information by using the
Web Agent, CLI, or SNMP.
To use the Web Agent to view the type of GBICs that are connected
to the modules in your switch, open the Physical Port Configuration
Web page. The type of GBIC that is connected to each port is
displayed in the Connector field on this Web page.
To open the Physical Port Configuration Web page:
1. Expand the Modules & Ports folders.
2. Click Configuration.
The Module Information Web page opens.
3. In the Ports column, click the number for the module that
you want to view GBIC types for.
The Physical Port Configuration Web page opens (Figure 5-2
for Gigabit modules and Figure 5-4 for 10/100 modules).
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1