Avaya Cajun P882 User Manual page 51

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Policing, which makes it possible for you to limit the
—
bandwidth for ingress traffic and drops frames when
traffic exceeds the limit.
New CLI commands for setting queue servicing for egress
—
traffic.
Ability to view and reset QoS statistics.
—
Ability to view buffer allocation.
—
For information on how to set up the QoS features, see
Chapter 21, "80-Series QoS."
Routing-only IP interfaces.
You can now set an IP interface to route but not allow
management of the switch. For information on how to set an
IP interface for routing only, see
Interfaces to the VLAN"
Reset individual modules by using a CLI command.
For information on how to reset an individual module, see
"reset-module" in Chapter 17, "Module," of the Command
Reference Guide for the Avaya P550R, P580, P880, and P882
Multiservice Switches, Version 5.3.1.
Debug mode
This mode displays system messages to help you troubleshoot
network problems. Use the set debug {on | off} CLI
command to enable and disable Debug mode. By default, this
mode is disabled.
Enhanced ability to manage user accounts.
These enhancements increase the security of the switch and
are as follows:
The switch administrator is now able to enable or disable
—
the manuf and diag user accounts, and the switch
retains the setting when you restart the switch.
Users with administrator access can change their own
—
password and the password of other users, excluding the
manuf and diag accounts. In earlier versions of software,
users with administrator access could change the
passwords for the manuf and diag accounts.
Users without administrator access, except for the manuf
and diag accounts, cannot change any passwords.
"Creating and Assigning IP
on page 9-5.
Introduction
1-23