Avaya Cajun P882 User Manual page 221

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1
Table 5-10. Keywords, Arguments, and Options
Keywords,
Arguments and
Options
<falling-threshold value>
<interval-seconds>
* Note: If you set the rising threshold value and the
falling threshold value close together, events
may be logged more often if the Notify option is
selected.
The CLI displays a confirmation message if you successfully enable
NEDR for a port or range of ports.
If no message displays, the port information was invalid. To verify
that NEDR is enabled on a port, enter the following CLI command:
<configure># show port network-error-
detection
If the port is not listed as enabled for NEDR, reenable NEDR on the
same port or ports again.
* Note: There is no Configuration Event for enabling or
disabling NEDR in the Event Log. However, you can find
out which ports have NEDR enabled using the following
CLI command:
>show port network-error-detection
Configuring Port Parameters
Explanation
The falling threshold.
After exceeding the rising threshold, NEDR
does not log another event in the event log
until the rate of CRC errors falls below the
falling threshold and then exceeds the rising
threshold again. The default setting is half
the rising threshold value (minimum is 0;
maximum is 65535).
How often NEDR checks the number of
errors occurring against the thresholds.
Enter a number of seconds.
The default setting is 2 seconds (minimum is
1; maximum is 65535).
2 of 2
5-43