Avaya Cajun P882 User Manual page 205

Parameter
Port VLAN
Trunk Mode
Frame Tags
VLAN Binding
Automatic
VLAN Creation
VTP Snooping
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1
15. Adjust the trap timer, if desired.
16. Select Enable from the Known Mode field pull-down
menu to suppress any packets that have unknown unicast
destination addresses and are flooded to this port.
For example, if a known end-station or file server is
connected to the port, there's no need to flood unknown
unicasts to that port. You must manually enter a static MAC
address for the station actually attached to the port. Reselect
Disable to prevent the suppressing of packets.
17. Select 3Com Default from the 3Com Mapping Table field
pull-down menu to specify how incoming tagged frames from
3Com equipment are mapped to VLANs. Refer to "Assigning
Ports to VLANs", in Chapter 4 for more information.
18. Mirror Port Always disabled.
19. Click APPLY to save your changes, or CANCEL to restore
previous settings.
* Note: Do not enable Automatic VLAN Creation and VTP
Snooping at the same time.
Table 5-5 describes the Switch Port Configuration dialog box
parameters.
Table 5-5. Switch Port Configuration Parameters
Definition
Specifies the VLAN assignment for this port.
Select the appropriate VLAN trunking format to make the
port a trunk, or Clear (default) if you do not want the port to
be a trunk. The trunk formats are IEEE 802.1Q, Multi-Layer,
and 3Com.
Select Ignore if you do not want to use received Frame VLAN
tags. Use is the default.
Note:
If you select ignore, the received frames are bound to
the port's default VLAN.
Select the port's outgoing VLAN binding type. Refer to
Table 5-7 for more information on VLAN binding options.
Select Enable to automatically create a VLAN each time the
port receives a frame from an unknown VLAN. Disable is the
default.
Select Enable to allow VTP Snooping on this port. Disable is
the default.
Configuring Port Parameters
1 of 2
5-27