Avaya Cajun P882 User Manual page 377

Parameter
VR ID
IP Address
Priority
Advertisement
Timer
Authorization
Type
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Table 9-30. Add VRRP Virtual Router Dialog Box Parameters
Definition
This is the virtual router identification number. The range is 1 -
255. The same VR ID can be used for multiple virtual routers as
long as the associated IP Interfaces are on different VLAN's (each
VR ID number can be used once per VLAN).
The default value is 1.
The range is 1-255 (decimal).
Enter the IP Address for the virtual router. This is known as the
Virtual IP Address (VIP). The VIP can be the same as the IP Address
of the associated Interface. This is known as IP Address Owner.
The VIP can also be a unique address. This is called non-Address
Owner. IP Address Owner and non-Address Owner are discussed
in more detail below under VRRP Considerations. The VIP must be
on the same subnet as the corresponding IP Interface.
The default value is 0.0.0.0.
Enter the Priority of the virtual router. If the router is the IP
Address Owner of the VIP (as described above), then the Priority
will automatically be set to 255 regardless of the value entered. If
the router is not the owner of the VIP, than any value in the range
of 1 - 254 can be entered. Note that the higher the value, the
higher Priority the virtual router will have.
The default value is 100.
Enter the value of the Advertisement Interval in seconds. This is
the time interval that the router will send out advertisements if it
is the Master. The range is from 1 - 255 seconds. The
Advertisement Interval also defines the time that a Backup will
wait until becoming Master. A Backup will become Master if it
does not receive an advertisement in approximately three times
the Advertisement Interval value. An Advertisement Interval will
allow for the fastest fail over time (approximately three seconds).
The default value is 1.
Select the Authentication Type for this virtual router. If None is
selected, then no Authentication Key will be used. If Simple is
selected, then the virtual router will employ Simple Text Password
authentication and use the password in the Authentication Key
field (described below).
The default value is None.
Configuring IP Routing
2 of 3
9-95