Chapter 11
CLI Commands
for OSPF
Removing NBMA Neighbors
Using the Web
Agent
Using the CLI
11-36
To set up NBMA neighbors on OSPF, you must first create an OSPF
interface.
1. After you create an OSPF interface, enter the following
command:
router ospf
The following prompt is displayed:
Avaya(configure router:ospf)#
2. Enter the following command at the prompt:
nbma-neighbor <ip address>
To remove the OSPF NBMA neighbor, enter the following
command at the Avaya(configure router:ospf)# prompt:
no nbma-neighbor <ip address>
You can remove NBMA neighbors using either the web agent or the
CLI.
To remove the NBMA neighbors using the web agent:
TBD
To remove the NBMA neighbors using the CLI, enter the following
command at the Avaya(configure router:rip)# prompt:
no nbma-neighbor <ip address>
* Note: Do not change the type of interface after you have
created it. If you need to change the interface type,
delete the old one and create a new one.
* Note: Poll-interval of NBMA interface decreases in value to 0,
during the operation. It does not affect the operation of
OSPF on an NBMA interface. A panic message will
display. Ignore this message.
* Note: NBMA RIP2 Poison Reverse in MD5 mode does not
advertise all the routes in the Route Table.
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1