Automatic Vlan Creation - Avaya Cajun P882 User Manual

Parameter
VLAN Binding
Automatic
VLAN Creation
VTP Snooping
CLI Command

Automatic VLAN Creation

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1
Table 5-6. Example 1. Trunk to Cisco Catalyst 5000
Recommended Setting
Bind to All - Binds the port to all VLANs known to
the switch.
Enable (Disable if using VTP Snooping) - Causes
the switch to learn new VLAN IDs that arrive at the
port, and then bind the port to these VLANs.
Enable - Causes the switch to update its VLANs as
they are created, deleted, or changed on the Catalyst.
To configure switch ports using the CLI, enter the following
command from Configure mode:
<configure># set port <options>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1for more details about this
command.
* Note: See the examples later in this section for
recommendations on how to set particular trunk port
connections.
Refer to "VLAN Operation" in Chapter 4 for more
information on creating VLANs.
You can configure port VLAN parameters using either
the Web Agent or the CLI.
Automatic VLAN creation is done by enabling the 'Automatic VLAN
Creation' parameter on an individual port under the 'Module &
Ports > Configuration > Switch Ports > name menu. With this
parameter enabled, the port will automatically create a VLAN each
time it receives a frame from an unknown VLAN ID in received
IEEE 802.1Q and Multi-Layer tagged frames.
* Note: The automatic VLAN creation feature does not create
entries in 3Com Mapping Tables.
Configuring Port Parameters
TM
2 of 2
5-29