Avaya Cajun P882 User Manual page 454

Chapter 12
Parameter
Select
Admin. State
Interface
VLAN
Network Number
Node Address
Encapsulation
Frame Type
Ticks
RIP
12-8
7. Click APPLY to save your changes or CANCEL to restore
previous settings.
Table 12-3. IPX Interface Dialog Box Parameters
Allows you to...
Select the Interface to be configured. This field id
displayed in the IPX Interfaces Dialog box not in the Add
Interfaces Dialog box.
Select the administration state of the interface.
Options include:
Up
Down
Enter the name of the IPX interface.Up to 31 Alpha-
numeric characters
Select the VLAN that corresponds to the IPX interface
you selected.
Note:
If you need to create a new VLAN, refer to
"Creating and Implementing VLANs" in
Chapter .4:
Enter the number of the IPX network you want to assign
to the IPX interface. This number is a hexadecimal 32 bit
(8 characters) number.
Displays the node address on which the IPX interface
resides. A 48-bit (12 characters) number.
This parameter is displayed in the IPX Interface dialog
box, not in the Add IPX Interface dialog box.
Select the format of the MAC header on the IPX packets
sent by the router on the interface. Formats include:
Ethernet II (Maximum Transmission Unit (MTU) =
1500)
Ethernet 802.2 (MTU = 1497)
Ethernet SNAP (MTU = 1492)
Ethernet 802.3 (MTU = 1500)
The default is Ethernet II
Specify the amount of time (in ticks) that the packet
takes to reach the network number you specified. A tick
is approximately 1/18th of a second. The default value is
1
Select Disable to prevent IPX RIP from routing globally.
This affects all IPX interfaces set up to use the IPX RIP
routing protocol. The default value is Enable.
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
1 of 2