Chapter 3
CLI Command
3-14
Figure 3-7. Temperature System Window
2.
Enter your desired temperature warnings in the Slot 1
Sensor, and the Backplane Sensor fields.
* Note: The Slot 2 Sensor column is displayed if the
switch has a standby supervisor. However,
temperature settings are displayed only for the
active supervisor. The temperature settings for
the standby supervisor are displayed as --
3.
Enter a temperature warning in the CPU Sensor field.
4.
Click APPLY to save your changes, or CANCEL to clear
your selection.
5.
If you change the temperature ranges for the active
supervisor, you must synchronize the active and standby
supervisors to copy the temperature settings to the standby
supervisor.
To configure the temperature warning systems using the CLI, enter
the following command from Configure mode:
<configure># set temperature <backplane-sensor>
<cpu-sensor> <probe> <supervisor-slot>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
°C
.