Chapter 1
1-24
Users logged in as manuf, diag, or root can change their
—
own passwords. However, these passwords revert to the
default passwords when you initialize NVRAM (nvram
initialize).
For information on how to disable the manuf and diag
accounts, see
"Disabling User Accounts"
Internal Error Detection and Recovery (IEDR)
This feature shuts down a port if its rate of internal CRC
errors exceeds the threshold setting. Currently you can
enable this feature only by using the CLI and only for ports
on 50-series and 80-series gigabit modules. For more
information about this feature, see
and
Recovery" in
Chapter 5, "Configuring Port
MAC address filters for 80-series port mirrors.
This feature makes it possible for you to set up port mirrors
that monitor only traffic with a specific source MAC address
or destination MAC address. For information on how to set
up Fabric mode 2 port mirrors that use MAC address filters,
see
"Setting Up Port Mirroring on a Switch in Fabric Mode 2"
on page 19-13.
Support for the following MIB groups and objects:
MIB II, documented in RFC 2863
—
•
Hunt group objects in the ifTable of the Interfaces Group
•
Hunt group objects in the ifXTable of the Interfaces
Group
Bridge MIB, documented in RFC 1493
—
•
Dot1dTp Group
•
Dot1dStatic Group
RMON MIB, documented in RFC 1757
—
•
Alarm Group
•
Event Group
RMON2 MIB, documented in RFC 2021
—
•
Trap Destination Table in the Probe Configuration Group
RFC 1483 MIB
—
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
on page 2-19.
"Internal Error Detection
Parameters."