Avaya Cajun P882 User Manual page 403

Creating
Trusted RIP
Neighbors
Using the CLI
Key Chains
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide,v5.3.1
3. Click CREATE. The Add Trusted RIP Neighbor dialog box
opens (Figure 10-4).
4. Click on the Select column checkbox for the Trusted Neighbor
and click on APPLY to save your changes
5. Click on the Select column checkbox for the Trusted Neighbor
and click on DELETE to delete the entry or CANCEL to
restore previous settings.
Figure 10-4. Add Trusted RIP Neighbors Dialog Box
6. Enter the IP address for the node that acts as the trusted RIP
neighbor in Network Address field.
7. Click APPLY to save your changes, or CANCEL to restore
previous settings.
To create a trusted RIP neighbor using the CLI enter the following
command from Configure mode:
> (configure)# route rip <cr>
> (configure router rip)# neighbor <ip-addr>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
In a full implementation of Key Chains, a Key Chain a set of Keys
each with its own set of parameters used for MD5 encryption. The
parameters are an encryption Key and the period of time that the
key is valid. This key must be identical on each device that will
participate in an exchange of information. In the case of RIP
(version 2 only), routers can use MD5 encryption to ensure that
only routing information packets (RIP packets) from authorized
routers are accepted.
Configuring RIP Routing
10-7