Parameter
Triggered
Updates
Update Pkt
Delay
Configuring RIP
on the Switch
Using the CLI
Modifying RIP Interfaces
Using the Web
Agent
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide,v5.3.1
Table 10-1. RIP Global Configuration Dialog Box Parameters
Allows you to...
Disable or Enable route updates that were triggered by a
topology change in the network to be added to the routing
table. The default is Enable.
Enter the value (in seconds) that represents the time delay
between successive RIP update packets to the neighbor, when
the update requires multiple packets. The default value is 1
second. The parameter range setting is 0-50 seconds.
3. Click APPLY to save your changes, or CANCEL to restore
previous settings.
To configure or modify the RIP parameters globally on your switch
using the CLI, enter the following command in router:rip mode:
(configure router:rip)# timers basic <update>
<invalid>
Update Timer <Msec> <Range:Min=10,Max=50>
(configure router:rip)# output-delay <delay>
(configure router:rip)# triggered updates <CR>
<enable,disable>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about these
commands.
You can modify RIP interfaces from either the Web Agent or the
CLI.
To modify RIP interfaces using the CLI from the Web Agent:
1. Select Interfaces from the Routing > IP > RIP group on the
Web Agent window. The RIP Interfaces dialog box opens
(Figure 10-2).
Configuring RIP Routing
2 of 2
10-3