Avaya Cajun P882 User Manual page 291

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Table 9-1. Add IP Interface Web Page Fields
Parameter Allows you to...
IP Routing Select enable or disable IP routing on the interface.
Options include:
Note:
Enable or disable RIP. The default value is Disable.
RIP
Enable or disable OSPF. The default value is
OSPF
Disable.
Note:
Specify the multicast protocol for the interface.
Multicast
Protocol Options include:
* Note: By Default, multicast forwarding is
Enable or disable Proxy ARP. The default value is
Proxy ARP
Disable.
Enable or disable ICMP Redirect (IDRP). The default
ICMP Redirect
value is Enable.
Enable or disable NetBIOS UDP Rebroadcasts. The
NetBIOS UDP
default value is Disable.
Rebroadcast
• Routing/Mgmt (Default) - Enables you to
manage the switch, from the Command Line
Interface (CLI) or the Web Agent, and
configure IP routing for the switch.
• Mgmt Only - Enables you to manage the
switch, however, IP routing is disabled for this
interface.
Do not enable routing protocols on an
interface configured for Mgmt Only since
the interface will act as an end point and
will not pass traffic.
• Routing Only - IP routing is enabled on the
interface, but you cannot manage the switch
through the interface. Routing Only interfaces
do not permit management traffic destined for
local interfaces but do allow all other traffic
including management traffic destined for
interfaces on other switches.
To Enable OSPF, The Admin State of the IP
interface must be set to down. Enable OSPF
and then set the Admin State to up.
• None (Default)
• DVMRP
• IGMP
disabled. To enable multicast
forwarding go to the IP Global
Configuration page.
Configuring IP Routing
3 of 4
9-9